Garage door won't close: sensor repair in Shelton

A door that starts down and comes straight back up is nearly always telling you about its safety sensors.

Call (475) 251-4304

In short

Blinking sensor light, door reversing, or a door that only closes while you hold the wall button: all three point to the photo-eye sensors. Clean and realign them first. If that doesn't work, call, and a technician in Shelton repairs the sensors and re-tests the opener's safety system.

Opener, rail and torsion spring above a garage door with windows

Doors that won't close in Shelton

Shelton runs from the Housatonic riverfront downtown up to White Hills, the most rural part of town. In White Hills and Huntington, garages are often detached or under the house, and mice are a real cause of sensor trouble: they chew the thin wire where it runs along the sill. If both sensor lights are out, look for a break in the wire before assuming the sensors have failed. In newer attached garages around Long Hill, a bumped bracket is the usual story.

Why a garage door refuses to close

  • Door starts down, then goes back up. Something is blocking, or seems to be blocking, the two safety sensors near the floor.
  • Opener light blinks and the door stays open. The sensors have lost sight of each other: a bumped bracket, a dirty lens or a broken wire.
  • Door closes only if you hold the wall button. That is the opener overriding its sensors. It tells you the sensors are the problem, and it is not a way to run the door day to day.
  • Door closes, touches the floor and reopens. The travel or force setting is off, or the floor has heaved and the door thinks it hit something.

Three safe checks before you call

  1. Look at the small lights on both sensors. Each should be on and steady.
  2. Wipe both lenses with a dry cloth and make sure nothing is leaning in the doorway.
  3. Gently turn the blinking sensor until its light goes steady, then try the remote again.

If that doesn't do it, stop there. Don't tape the sensors together or bypass them.

Fixing it properly

Most of these visits are short. Sensors are realigned or replaced as a matched pair, damaged wire is rerun and secured, and the opener's travel and force are set for your door. If the opener is old enough that it has no working safety reverse at all, the technician will say so and explain the options, and nothing is replaced without your say-so.

Around Shelton

  • Long Hill: Between Bridgeport Avenue and Huntington, mostly post-war homes.
  • Pine Rock Park: A hillside neighborhood of compact houses and tight driveways.

See the full Shelton service area.

Garage door won't budge? Call first, force it never.

Keep people and pets away from a door that's stuck or crooked, unplug the opener, and give us a call.

Call (475) 251-4304
Call (475) 251-4304